Diagnosing Issues with Prints via Photo

[csader]

Does it make sense to start a thread to diagnose issues with calibration and printer hardware/software issues by showing prints?


As a fairly new 3D Printer owner, I could see a lot of value in seeing examples of not-quite-right prints and getting feedback from more advanced users on how to diagnose and fix those issues. I know there is a wiki like this somewhere, but I didn't find it to be as useful as I'm imagining this will be, as it wasn't specific to our MakerFarm units.


Thoughts?

Here's mine to start...I'm seeing lots of this "waviness" happening in my prints. Its almost as if there's some wobble happening somewhere along the X Axis, but that's a complete guess on my part.