Results 1 to 4 of 4
Thread: Y Axis Issue with Marlin
Threaded View
-
12-22-2014, 06:04 PM #1
- Join Date
- Dec 2014
- Posts
- 2
Y Axis Issue with Marlin
Hello everyone,
It's my first time here. Hopefully I can contribute and offer help to others as well.
I just upgraded my Rigidbot electronics from a Rigidbot board to an Azteeg X3. So far I'm very impressed by it, but I'm having a software issue. I downloaded the latest version of Marlin and changed a few settings in configuration.h. From what I can see, the X and Y axes are configured the same. Only problem is, the Y axis doesn't work properly. It moves, but not far enough. Moving it 50mm on Repetier Host does not move the bed 50mm. When I try to print something, it comes out squished on the Y axis.
I've tried swapping motors as well as drivers to no avail. To make sure it wasn't just that slot in my board, I tried other slots and switched up the pins.h file. Using various combinations of drivers, motors, and slots, I've found that it only affects anything assigned in pins.h as the Y axis. I have no idea why this is happening.
I've uploaded a zip of the firmware here: Azteeg X3.zip
Thanks in a advance
-Dylan
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)