Results 1 to 10 of 19
Threaded View
-
12-17-2014, 11:22 AM #6
- Join Date
- Nov 2014
- Posts
- 19
Oh, right. It's a Solidoodle 4. I reflashed with what I think I was told is the official firmware. http://support.solidoodle.com/hc/en-...e-Source-Files
The configurations? Well it gets removed. But I hadn't modified it.
As for slicer and program settings, well they are stored in the PC so no change was done on those.
Pics:
http://www.thingiverse.com/thing:79737
Happens both with prints with very wide bottoms as well as thin ones (like in the last pic, which is printed halfway). Both small (few cm) and big (10cm+)
The parts that do not warp are attached to the bed pretty strongly.
(And the black stuff on the prints are grease (got on it later))
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion