Results 1 to 10 of 21
Thread: Newbie
Threaded View
-
10-22-2014, 10:59 AM #1
- Join Date
- Oct 2014
- Posts
- 93
Newbie
Hi,
Just got a flashforge dual (well a replica of one) see this link : http://www.ebay.co.uk/itm/3D-PRINTER...E:L:OC:GB:3160
having a few issues you guys might be able to help with.
1, the z-axis bar (the up and down one) has a lot of play towards the top, is this common, can a stablizer bracket be fabricated to stop the wobble ????
2, i only seem to be able to get 1 or 2 good prints a time, before it goes to hell,
3, what type of oil do i use to lube the motors, gears etc (directions on what to oil would be helpful)
ok there the biggies, print settings for free ??? pla are as follows
extruder temp at 205
bed temp at 80
leveled the bed then wiped over with acetone before printing.
as of this moment its printing an ipod stand
http://www.thingiverse.com/thing:408000
and its coming out pretty clean, only at 11% though so we will see, infill is set to 30% (i know its high but i really want this not to flop over).
should there be anything else i should do ????
Ghosty
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help