Soon to be new owner of a Creator Pro

[Geoff]

Trying to print that Marvin keychain figure, can't seem to make it stop warping:

MarvinPLA.jpg
PLA 205C Extruder & 55C BED (glass)

This is also with a 120mm fan on the side of the platform blowing into the case/bed.

Any ideas?

Lower the PLA temp to 180-190

TBH I never print PLA higher than 200c, and I have 18 types here. If you get any clicking from the extruder due to the lower heat, print a bit slower and see how it goes.

you can't break your printer by extruding at a low temperature, all it will do is 'click click click' (sure if you let it click for long enough it will shred the filament ) but a couple of clicks wont kill it. Just see what the lowest you can extrude at, especially with PLA.