Results 1 to 2 of 2
Thread: Hot End Thermistor Replacement
Threaded View
-
10-15-2014, 09:15 AM #1
- Join Date
- Oct 2014
- Posts
- 41
Hot End Thermistor Replacement
Hi All,
Ive managed to break my existing hot end thermistor in my Ordbot Hadron, so ordered some new ones. I noticed that the existing thermistor had a clear cover / insulation over the two wires, however the new ones that I ordered dont.
Is anyone able to advise if it essential that insulation is used to keep the wires from touching as Im struggling to find any.
thanks in advance
GrahamLast edited by grezmel; 10-15-2014 at 02:04 PM.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion