Results 1 to 10 of 23
Thread: I Can't Get A Break
Threaded View
-
10-14-2014, 12:09 AM #1
I Can't Get A Break
If you've checked my recent posts, I've been having trouble with filament recently. I finally fixed the issue and printed off some quadcopter pieces. I noticed the next morning that they had layer separation on them, which was weird being that they were in a small, closed space (better environmental heat) and they were short (better inner heat). When I tried heating up my bed for tonight's prints, it wouldn't heat. The screw-down connectors for my bed are melted. The board has burn marks on it and the connector is done. I can't think of what to do next other than buy a new board or find a way to run the bed off of D09.
Any tips?
Photo Oct 14, 12 08 28 AM.jpg
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help