Results 1 to 10 of 14
Threaded View
-
09-29-2014, 02:04 PM #2
Welcome to forums! Congratulations on your printer!
I used a piece of regular glass from the local hardware store and they cut it to 10"x10" for free. Then I used a glass cutter like the one below to score the glass on a diagonal at each corner to form an isosceles triangle with the two edges of the same length being about half an inch (IIRC). Then, I had my kid hold down the glass using a straightedge at the scoring line which was also aligned with the sharp edge of a table below. Then, I took a pair of vise-grips and snapped off the corner. Remember to wear safety glasses.
0663738-23.jpg
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion