Results 1 to 10 of 30
Thread: My Makerfarm Prusa i3v 8" build
Threaded View
-
09-22-2014, 07:09 PM #9
Oh, yeah, could be a problem in the endstop wiring too. Double check which two of the three pins you're using in the 3-pin endstop connectors. You might have the endstop switches incorrectly wired between +5 and ground. That would not be good.
EDIT: Looking at the RAMPS board mounted on the printer, the endstop switches go to the two pins on the left side of the 3-pin connectors. If they are installed off a pin to the right or the connectors are installed rotated 180-degrees, the endstop switches will be wired between +5 and ground. The motor and thermistor wiring wouldn't be a factor here since neither tie directly to the 5v distribution.Last edited by printbus; 09-23-2014 at 09:03 AM.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help