Results 1 to 10 of 52
Threaded View
-
09-19-2014, 10:14 AM #11
Just to show you it can be done, I had temporarily installed the clough42 print cooler on the left side. The shroud mount was bolted onto a piece of hobby plywood shaped to follow the X-carriage, except it went higher. You can't see it in the picture, but there's a hole in the plywood below the shroud mount that was used with the existing screw location on the left side of the X-carriage.
I say this was temporary in that I only used it until I could get a blower system (not a fan) in place, also mounted to the side. I found the airflow lacking with a shrouded axial fan, since axial fans aren't designed to operate with the backpressure that a shroud creates.Last edited by printbus; 09-19-2014 at 10:20 AM.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion