That is a great idea. For some reason, I thought you had also switched to clough42's extruder fan setup.
I need to figure out how to remove the melted plastic from the extruder. Maybe soak it in acetone overnight.
Nope. I have LEDs mounted under the carriage and had glued-up the X-carriage prior to painting so for now I'm stuck. To clean mine up, I just turned on the heater and wiped it off carefully as the block got hot.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion