Results 1 to 3 of 3
Threaded View
-
08-14-2014, 05:08 PM #1
- Join Date
- May 2014
- Posts
- 100
Using ATX power supply for power a Delta Printer
The ATX power supply I am using is the Corsair TX 650 Watt psu. It has 12V 52A on a single rail. My question is that the connectors have multiple single 12V wires. If I am powering my controller board with say just 1 wire and a separate heatbed with another single wire, is this appropriate to wire the the circuit in this manner?
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion