Results 1 to 10 of 33
Thread: Black ABS
Threaded View
-
08-08-2014, 06:14 AM #21
so basically print the black at lower temp then, say 225 or 220 maybe ?
Got a new roll of black from a new supplier (to me) off ebay yesterday - haven't tried it yet . But the transparent filament I bought is great (again, different supplier).
Prices are really coming down - the three rolls I bought were all under £14 each including postage (can't remmber excatly but somewhere around £13.60 ish)
The transparent is really good stuff, nice sharp, clean prints.
I'll try the silver and black later.
For the record the filament that came with the printer was a roll of blue - that was printing great, but something in it blocked the print nozzle - and I haven't touched it since.
The FF white, on the other hand is really excellent. Again, very clean sharp prints even at .3 & .4 I went through about 3/4 of the roll in 2 days with zero issues and zero stringing even on large multipart prints.Last edited by curious aardvark; 08-08-2014 at 06:19 AM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion