Results 1 to 10 of 129
Threaded View
-
08-06-2014, 05:39 PM #11
Drum roll:
It took ONE HOUR AND 8 MINUTES!!!! To make what the Rep 2 does in 16 minutes! WTF??
Bear in mind this is on top of that darn Z-height calibration and heating which total around 15 minutes per build.
Okay, calm down, maybe it's making .05mm layers at 15mm/sec or something? I can't see the slice because it is inside the machine. Maybe it is something in the firmware? The support tech wanted to know what version firmware I was on, and I have read that there have been a LOT of firmware updates on these things.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion