Results 1 to 10 of 42
Threaded View
-
07-30-2014, 09:21 AM #13
actually I just measured it with the calipers. It's only 1.25 mm. Better heat transfer from the bed. And it's still pretty strong.
Just modelled a holder that will hold 7 sheets - assuming it prints !
But as it's a solid base I can use raft and that usually works okay
Now I just need to come up with a better way to attach the glass than bulldog clips as the heads always seem to hit the clips - no matter where I put them.
Also bought some vinyl based hairspray and a couple more sheets of glass.
I will try everything !Last edited by curious aardvark; 07-30-2014 at 09:47 AM.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion