Printer noob - Can't print consistently on FFCX

[Geoff]

Not for the cost and machine complexity involved. It isn't worth $1000 bucks.

Someone said there is autoleveling for $40 bucks, I have yet to see a link to that piece of hardware. lol. Once you are leveled and have a solid build plate platform, the z-axis switch takes care of your build plate height in relation to the nozzle. This is set every time a print is started.

Then you are very inexperienced in simple electronics. It can be done for even less than $40, I was being safe at $40. What exactly do you think a Z probe is? LOL There are 8 ways to make one that I can think of using normal components lying around the house. An old VCR would pretty much give you all the components you need - but you knew that of course didnt you?

Stop being such a douchebag and jumping on everyones suggestions. I've been reading your posts and that's all you seem to do lately.