Quote Originally Posted by Mjolinor View Post
Thanks for that. I had been all over it looking for the problem but when I stick it at the same angle as your picture I can see them. As the upper set and the lower set are just copies of each other then it must be a bug in Freecad.
This is indeed disheartening as I will have to redraw it in something else. :bawling:
Learn how to fix it or you will most likely run into the same issue again, and you will be right round in a circle. If you don't know how you caused it when you modelled, then chances are you most likely will repeat the problem. Learn from your mistakes