Results 1 to 10 of 321
Thread: Flashforge 3D Creator forum.
Threaded View
-
06-17-2014, 02:29 PM #11
- Join Date
- Jun 2014
- Posts
- 63
thanks for the tips and initial settings. hope i can contribute in this forum.
[edit1]
iam having a hard time with FlashForge. cant get filament to stick to HBP with blue tape.
calibrated HBP 2 times. increase temp to 80 already. filament will wont stick properly.
also i cant maximize build area. i can only build small part near center.
[edit2]
get to stick to HBP (too sticky). now my problem is print is a bit wavy vertically, every 5mm. and top layer of printed box does not stick well.Last edited by palawanisland; 06-20-2014 at 01:55 AM.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion