Close



Results 1 to 3 of 3

Thread: Sloopy Prints.

Threaded View

  1. #1

    Sloopy Prints.

    Howdy all, I have a ANYCUBIC Mega X. Prints weren't sticking so I got a new glass bed. Nozzle was underextruding (probably) so I replaced the nozzle. I am getting really sloppy prints, albeit better then they were, but can't i do better with slicer settings (Cura)? I am using PLA, nozzle width=0.4mm. I have varied temperature, layer height, speed, but I don't seem to be getting nice prints. I have enclosed a picture. the part is about 32 mm.
    Attached Images Attached Images

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •