Results 1 to 8 of 8
Threaded View
-
06-12-2023, 10:40 AM #1
- Join Date
- Jun 2023
- Posts
- 5
Flow Cube a Mess. Prints are a Mess
Hello everyone,I print with ASA and have very little problems other than ringing which I cleared up but now have this miserable condition that I can not pinpoint with settings. I tried to take my settings back to standard with no help. Though 40 mm/s might be high for ASA I was printing fine at that speed on my QIDI X Plus for many prints. The language barrier makes it tough to get solid answers from QIDI so I'm hoping someone can point me in the right direction.Two sides of the cube print smooth while the other two are a mess. The results of the test suggests I should run at 37% flow.. heheheheDo I have a mechanical issue here or whhhhaaaaat?!
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion