Results 1 to 2 of 2
Thread: Roller Wheel Issue?
Threaded View
-
04-08-2023, 01:44 PM #1
- Join Date
- Jan 2023
- Posts
- 6
Roller Wheel Issue?
When I received my Ender 3 S1 and first assembled it I noticed the X and Y motion had what felt like a dead spot in the rollers or the aluminum guide itself. So I adjusted the roller tension which was indeed too tight. The dead spot was now only slightly noticeable, and over time seemed to diminish.
Lately printing in spiral/vase mode I notice at a certain elevation the layers are off like something randomly shifted. I'm printing at a relatively slow 50mm/s, .2mm layer. I notice this defect to varying degrees on similar prints.
Spiral Issue.jpg
I know its tough to quantify but how smooth should the X?Y axis move? Does the rolling resistance need to be perfectly constant or is some deviation OK?
Printer will print perfect...
Yesterday, 10:44 AM in Tips, Tricks and Tech Help