Results 1 to 4 of 4
Threaded View
-
12-21-2022, 11:34 AM #1
- Join Date
- Dec 2022
- Posts
- 2
Anycubic Kobra Go test print going haywire about halfway in
Hi All,I am a newbie to the hobby. I am looking for some advice on where to start troubleshooting. Just did my first test print. Got about halfway through and I believe it jumped off the bed because its a stringy mess when returning to my bench 5 minutes later so I had to stop it. I have an Anycubic Kobra Go printer and I am using their branded red PLA as a filament. PLA is set to 200 degrees, bed heat I believe I set to 80 deg. 0.2mm standard thickness and infill was set to 15%. I believe this happened because the model jumped off the bed. I will include a picture. I went ahead and purchased a Magicgoo branded glue stick to see if that will help keep my print attached to the bed. Do you guys/gals think that this was the issue? Adhesion to the print bed? I am also going to slow the printer down and reduce speed because it was set to 100 on the dial. I might bump the PLA temp slightly at the nozzle. Any other recommendations to get this test print actually finishing? See image attached for the mess I created lol Thanks in advance for your comments. I am excited to get into this new hobby. It looks like a lot of fun!Hooch
Printer will print perfect...
Yesterday, 10:44 AM in Tips, Tricks and Tech Help