Results 1 to 8 of 8
Thread: E3D hot end clogging.....
Threaded View
-
06-05-2014, 08:12 AM #1
- Join Date
- Apr 2014
- Posts
- 27
E3D hot end clogging.....
So when I'm done printing with my E3D hotend, I have an issue. It seems almost impossible to get the filament out of it. In the on other extruders I've been able to just pull it out after heating. Now with this, I can't figure out how to get it to come out. Am I the only person in the world with this problem? Is there a tip or trick for getting it out?
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion