Close



Results 1 to 1 of 1

Threaded View

  1. #1
    Student
    Join Date
    Aug 2021
    Location
    Aubrey TX
    Posts
    10

    Aquila - VoxelMaker & Cura - Rough 2nd 3rd Layers

    I tried posting in Tips, Tricks and Help but got no help. Hopefully the General discussion Board will do better ... ... Aquila, now equipted with an Ender 3 Direct Drive Extruder/Hot End, using VoxelMaker and Cura slicers .... ... Initial Layer is GREAT, very smooth, sticks well ... 2nd Layer shows some rough spots and sometimes a 'wave like pattern' ... 3rd layer gets rougher .... after infill completes, roughness continues. 2nd & 3rd Layer appear to 'bubble up' around the edges of finished project (see attached picture) ... I am stuck ... would like suggestions on where to look for issues in setup and what to fiddle with to make work ... thank you
    Attached Images Attached Images

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •