Results 1 to 1 of 1
Threaded View
-
07-26-2022, 11:24 AM #1
- Join Date
- Aug 2021
- Location
- Aubrey TX
- Posts
- 9
Aquila - VoxelMaker & Cura - Rough 2nd 3rd Layers
Aquila, now equipted with an Ender 3 Direct Drive Extruder/Hot End, using VoxelMaker and Cura slicers .... ... Initial Layer is GREAT, very smooth, sticks well ... 2nd Layer shows some rough spots and sometimes a 'wave like pattern' ... 3rd layer gets rougher .... after infill completes, roughness continues. 2nd & 3rd Layer appear to 'bubble up' around the edges of finished project (see attached picture) ... I am stuck ... would like suggestions on where to look for issues in setup and what to fiddle with to make work ... thank you
Last edited by TomH; 07-26-2022 at 11:34 AM. Reason: Adding pictures
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help