Close



Results 1 to 2 of 2

Threaded View

  1. #1

    Red face Struggling with dots on prints

    Hi All, I am struggling with getting dots on my prints. I use Ultimaker Cura as my slicing software and most settings are the standard defaults. My prints has dots on them at the back. I am attaching a pic of a yorkie I printed. I decided to print the infamous xyz cube, and yes they are very obvious in this print, attached is the view of the front of the cube as well as the back. I am using a ender 3 v2 printer. Any suggestions would be greatly appreciated. What have I done: Upgraded the springs to remove bit of movement that was on the build plate. Spent hours on bed levelling.Any other suggestions. Thanks in advanceClydie
    Attached Images Attached Images

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •