Results 1 to 5 of 5
Thread: Print isn't sticking to my bed
Threaded View
-
05-11-2022, 10:13 AM #1
- Join Date
- May 2022
- Location
- Hannibal Missouri
- Posts
- 4
Print isn't sticking to my bed
I am seeming to have a lot of trouble getting my first layer down. the filament just keeps sticking to the nozzle and failing. it also make a popping sounds when printing. I tried leveling by bed over and over but that didn't seem to help much at all. I then thought that maybe something was wrong with the Gantry so I tried tightening my gantry to the X-axis. As you could guess, that did not work either. help with this would be greatly appreciated.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion