Results 1 to 10 of 12
Threaded View
-
05-22-2014, 01:53 AM #3
- Join Date
- May 2014
- Location
- Scotland
- Posts
- 23
I'll try cutting it at an angle. I went over the guide you put up Geoff and turned it up to 245 degrees and still nothing. Pushed down through the clicking and nothing. Only other thing I can think about is the whole taking it apart and drilling it but I'm too new to all this stuff and do t want to break it. Shame..only a week old and spent more time fixing it than using it. Lol still ill keep trying and hopefully something will work.
Thanks again for the response
gav
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion