Results 1 to 4 of 4
Threaded View
-
05-20-2014, 12:30 PM #1
- Join Date
- May 2014
- Posts
- 1
Different colours causing problems
I have been using clear ABS filament to print with my Replicator 2 printer and switched to red ABS filament. I am having a problem getting the print to stick to the table. I have leveled the table with no luck so I used the same settings but switched back to clear ABS and the print was fine. Is their a different setting for coloured filament? Seems odd but I have not been able find anything else.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion