TronXY-2 Pro filament extrusion problem

[jonogunn]

Hi new here and new to 3D printing. I got a used TronXY-2 Pro off craiglist and everything was fine with the first few prints but then I ran out of the filament that came with the machine.I waited a week for some Anet filament to come in the mail and hooked it up to the machine. When I do a manual extrusion to test it out everything seems fine and it comes out thick and consistent.However once I go for a print it comes out thin and inconsistent with occasion small blobs. I took the nozzle out to check if it's blocked but I could see right through the hole so I assume it's okay.I've attached a couple of photos and I'm stumped. I tried increasing the temperature as well but no luck.