Results 1 to 3 of 3
Thread: Is this thermal runaway?
Threaded View
-
05-30-2021, 11:07 AM #1
- Join Date
- May 2021
- Posts
- 4
Is this thermal runaway?
I have a standard Creality Ender 3, probably bought it new in 2019 well before V2. I ordered a V2 a few weeks ago which had a defective board in the sense that the micro SD card wouldn't latch. Amazon sent me a new one board. Installed it, works fine. I took the bad one and put it in my old Ender 3 thinking I would rig something to hold the card in place. That works except for one thing-- the bed gets hotter'n hell. I usually run 60c and the gcode of my test program reflects that. But as I watch the display, it hits 80c pretty quickly so I shut it down. There seem to be settings for the machine itself which I also set at 60c. The heater ignored that as well as the gcode heat setting. Any ideas? I appreciate any help.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion