Results 1 to 9 of 9
Thread: X/Y wobbling/waves
Threaded View
-
05-14-2014, 08:14 AM #1
- Join Date
- May 2014
- Location
- Belgium
- Posts
- 15
X/Y wobbling/waves
Hello,
I've been printing for a while now and there is 1 problem I can't seem to figure out what is causing it, I'm guessing belt tension but I think my belts are at the right tension.
I have noticeable waves in the x and y direction. My printer is a K8200 from velleman (aka 3Drag). Table moves in X and Y direction, extruder moves in Z-direction.
Since I print in a color that is hard to photograph i'll post a photo of a picture I found on the internet that shows exactly the same behavior as my printer:
7172350812_5ebcfe8670_b.jpg
Anyone that had this problem too? And managed to fix it?
Design not printing solid
09-17-2024, 06:12 AM in 3D Modeling, Design, Scanners