Results 1 to 5 of 5
Thread: Help ! Creality Cr10 Pro
Threaded View
-
02-07-2021, 02:40 AM #1
- Join Date
- Feb 2021
- Posts
- 6
Help ! Creality Cr10 Pro
Hi - This is my fourth print following a clicking filament drive problem? I cleared the nozzle, made sure the feed tube was correctly inserted into the hot end. It printed the raft good, I think?, then the deformation started to happen? the nozzle even scrapped across the filament ? Any thoughts as to what is going on? Please see pic attached.
Last edited by bullet11300; 02-07-2021 at 04:00 AM.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion