Results 1 to 10 of 68
Threaded View
-
05-07-2014, 10:55 AM #10
I'm Jealous!!! That is amazing! You must have very good equipment!
You can try:
M48 x 100 y 48 V4 E L 8
To beat on the hardware a little bit harder. That will engage and retract the Z-Probe for each measurement and move the X & Y axis around between measurements. Probably, you will get similar results, but not as good as the one you just posted.Last edited by Roxy; 05-07-2014 at 11:00 AM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion