Results 1 to 10 of 13
Thread: Help needed: layer shifting
Threaded View
-
12-01-2020, 07:27 AM #2
As you have stated the X-Axis seems a bit stiff when moved to far left this can be caused by binding.
This could mean that to smooth rod holder are out of alignment. Remove the binding nd you solve the problem.
And this is what I would call warranty fraud because if you told them of the problem before and they never could fix it.
As it was reported previous to end of warranty then it still should be replaced under warranty for a lemon law replacement...
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion