Results 1 to 10 of 13
Thread: ATMEGA blew up
Threaded View
-
11-19-2020, 05:32 AM #1
ATMEGA blew up
Hey,
Apparently I am an idiot. But an idiot in desperate need of your help. I installed and started three 3D printers. Recently I wanted to change the stepsticks to more silent ones. So I did. However, I inadvertently loaded one in reverse and it threw out Atmega. BOOM! After the change to LCD I only have FFFFFFF. Replacing RAMPS, or LCD does not help.
I combine both. I load different configurations, different pins and it is still the same thing. Is there any chance for a rescue?
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help