Results 1 to 10 of 12
Thread: PET - not pet-g
Threaded View
-
11-11-2020, 07:42 AM #11
I've had no stringing issues with either pet-g or pet.
Maybe because I don't keep the filament sealed, dunno.
I've put the roll of PET outside under the balcony - where it's open to the elements without actually getting rained on.
To test my: 'it works better after absorbing some moisture' theory.
PET's basically water resistant - so it won't get soggy.
But it was weird that the first 2-300gms were brilliant and then it did start stringing with the exact same settings.
I figure by leaving it outside in a damp uk november, it should accelerate the results I got from 2 years in my workshop - which is not much warmer, but a lot dryer :-)
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help