Results 1 to 6 of 6
Threaded View
-
09-30-2020, 10:57 AM #5
- Join Date
- Sep 2020
- Posts
- 2
Hey thank you for the replies. I will try to get in there with an exacto and "trumpet" the base of the tube, that makes sense. I've been under the extruder with a flash light and basically lockpicking tools trying to guide the filament through the two gears to get into the tube. I think I've sheared off half of this PLA tubing the printer came with at this point.
I'm a pretty simple fellow, so replacing all these parts seems daunting, but from all yalls information I think I've been able to find a few youtube videos on how to take this extruder apart / replace it.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion