Results 1 to 7 of 7
Threaded View
-
09-21-2020, 03:06 PM #1
New purchase older wooden frame FlashForge Dual Extruder Creator
OK I just picked up something I have wanted for a while. I always loved the look of these older wooden framed FlashForge dual 3D printer. I picked this up at a garage sale for $50. I have ran it through all it paces and it all seems to work great.
But I have not tried to print yet. In doing my due diligence (LOL) it seems that I must run ReplicatorG for this? Is this correct?
If anyone can point me to an PDF of the manual that would be great.
I have emailed FlashForge with firmware questions and software limitations for this unit (yes I sent them the serial number). I have always liked the 'garage build' look of this specific unit but just could not afford the almost $2000 when they were new. I have printers that I run but I want this for nostalgia reasons.
Any help anyone can give me in bring this fully back up to running and printing would be very appreciated. It is a clean unit with right at a total of 20 hours of run time on it.
FlashForge 1.jpg
FlashForge 2.jpg
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help