Close



Results 1 to 2 of 2

Threaded View

  1. #1

    Help with updating firmware?

    (Let me just start off by saying I have very little experience with this type of thing so go easy on me) I have a CR-10s Pro and I cant seem to figure out how to update my firmware. Any tutorial i have watched either hasn't worked or is out of date. Could someone by chance give me some steps on how to do it? The reason I want to do this is because I bought a new sensor omegle xender for my printer and it works but when I begin a print the nozzle goes down to detect the bed, up and then down again to detect the bed again like normal, but then the nozzle just dives into the bed and nearly breaks the nozzle. Also the nozzle goes off to the top left corner instead of the middle when beginning a print. I'm just assuming this is a firmware problem so I just wanted to try updating it to the normal firmware since the current firmware I have is the tinymachines one I believe? Please help!
    Last edited by CarsonGrey; 09-10-2020 at 12:58 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •