Results 1 to 5 of 5
Thread: PETG small hole adhesion
Threaded View
-
08-29-2020, 05:01 AM #1
- Join Date
- Aug 2020
- Location
- Wyckoff NJ
- Posts
- 9
PETG small hole adhesion
I do a lot of flat parts with small holes using PETG on painters tape. The first layer at the small holes often creates a mess due to poor adhesion. It starts to improve after laying the straight lines between holes. Is there a way to get the printer to do the straight lines first and then the circle for the holes after? I think it would stick better that way.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion