Results 1 to 10 of 18
Threaded View
-
08-07-2020, 01:57 PM #7
So you are basing your opinion of all Creality printers on the Ender 3 is what you are saying? There are literally tens of thousands of satisfied Ender 3 owners who would disagree with you. But your engineering knowledge invalidates their experience and opinions of course.
Yes a direct drive extruder is an improvement over a Bowden setup. Is it a absolute must to achieve good quality prints? No, it is not. And most people do not need, or want to print at 200mm/s. 3D printing isn't a race for most people, other than yourself and perhaps a few others. The speed a printer can operate at is absolutely no indication as to its ability to produce great prints.
Your not doing anyone here a favor by denigrating their choice of printer or by steering them away from some very capable printers based on your personally assumed knowledge of 3D printer engineering.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion