Results 1 to 10 of 11
Threaded View
-
08-04-2020, 02:04 PM #1
Has anyone had a good experience with the Ender series?
I am a total noob to this universe and I just purchased the Ender 3X. It hasn't been delivered yet. I thought I did enough research but after searching here for recommended upgrades (i.e. BLtouch, all metal feeder, Raspberry pi, or TL Smoother) I have run into many, many posts stating that the Ender 3 (the original) was basically not worth the box it is shipped in. I plan to give it my best try and learn for myself if it's for me or not. But I just wanted to know if anyone more experienced than myself had any good things to say about the Ender. Any comments would be appreciated.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion