I am experiencing issues with printing multiple parts in TPU95+. If I print 1 part it works perfectly fine, with no issues whatsoever.
As can be seen in the picture, it actually starts fine with no issues. But when it gets to the top half of the parts it begins being to loose.
IMG_20200624_074755.jpg

I am using the following settings:
AA 0.4 Nozzle.
Layer Height: 0,2mm
Wall Thickness: 1,1mm
Top/Bottom Thickness: 1,1mm
Infill: 6%
With PVA support.

I am hoping some of you have experienced an issue like this, and is able to help me.
Below you can see a bad and a good part.
IMG_20200624_093653.jpgIMG_20200624_093702.jpg