Yet another 3D Printer has launched a campaign on Kickstarter today. It's the Mamba3D Printer, which is an open source printer that is priced starting at 625Euros ($864). The printer is made completely of metal, and has a nice 200x200x200mm build area.



It uses 1.75 mm filament, has a .4mm nozzel and prints in a resolution up to 50 microns. It also uses an all metal hot-end.



The prints that they have as examples look really good too.


The Mamba3D printer is a complete kit consisting of:

  • Aluminum frame and plates
  • Electronics with preloaded firmware
  • Motors, wires etc. [no soldering needed]
  • Mamba3D extruder drive
  • Hot-end
  • All other hardware needed to build your own printer
  • Detailed build manual
  • Samplepack of premium Colorfabb PLA to get you started

Have any of you backed it?