Close



Results 1 to 5 of 5

Threaded View

  1. #1

    New to 3D printing and need guidence.

    Hello everyone, I am new to 3D printing. I am looking to start tuning the printer as all the videos I see on Youtube recommend that I do. I am having a hard time figuring out where to start and with all the videos and websites to choose from, I am starting to get a bit of anxiety.

    Current set up
    1. Ender Pro 3 with SKR Mini E3 1.2 board due to extruder driver failure - board has origional firmware it came with
    2. Matterhackers blue 1.75 ABS
    3. 0.4 extruder tip
    4. bed temp set to 100°C
    5. Nozzle temp set to 225°C
    6. Utilimaker Cura 4.5 (Read that this was the best free cutting software. May buy better software in future after trying out the 3D printing life and like it)
    7. Dumb 3D printing newbie

    I will post picture of a Calibration cube I found a file for and a 9mm bullet I tried to design in TinkerCAD
    Attached Images Attached Images

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •