Results 1 to 8 of 8
Threaded View
-
04-04-2020, 12:05 PM #1
- Join Date
- Apr 2020
- Location
- Southern California
- Posts
- 2
removing filament always jams extruder (Anycubic Mega-S)
Hey y'all. Thanks ahead of time for your insights!
I'm printing PLA on an Anycubic Mega-S, and every time I go to remove the filament for a color swap, it jams in the extruder. Even with the release lever engaged, the filament jams because the end of it melts into a small "blob" that's wider than the diameter of the filament itself. I've tried heating up the hot end in order to feed in the filament and melt the tip a little before pulling it out, and that doesn't seem to help much. Any suggestions? I'm afraid I'm just going to break the extruder if I just keep forcing it out.
Thank you!
Printer will print perfect...
Yesterday, 10:44 AM in Tips, Tricks and Tech Help