Results 1 to 10 of 13
Thread: Marlin 2.0 Auto Leveling Problem
Threaded View
-
04-01-2020, 03:29 PM #11
They did Update this Code!!
// Set the boundaries for probing (where the probe can reach).
#define MIN_PROBE_EDGE_LEFT MIN_PROBE_EDGE + 10
#define MIN_PROBE_EDGE_RIGHT (X_BED_SIZE - (MIN_PROBE_EDGE + 10))
#define MIN_PROBE_EDGE_FRONT MIN_PROBE_EDGE + 8 // +8 For Your Sensor
#define MIN_PROBE_EDGE_BACK (Y_BED_SIZE - (MIN_PROBE_EDGE)) // + 33 For Your Sensor
So Sorry... Mistake
This is for the Newer versions of Marlin above alphaLast edited by Roberts_Clif; 04-01-2020 at 06:38 PM.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion