Results 1 to 10 of 10
Threaded View
-
03-28-2020, 04:11 PM #1
- Join Date
- Jan 2020
- Location
- Bel Air Md
- Posts
- 181
Prints not sticking to new Borosilicate bed
Hello Just replaced worn out stock bed that came with Ender 3 Pro. Had many successful prints with that bed. But even with cleaning it had too many ghost images and started to need a comealong to remove prints. So I ordered a Borosilicate glass bed and new updated adjustment springs. I cleaned bed, heated it up to 60 and checked for flatness. I'll have to say it is flat. What my problem is the Cell phone case I've started 3 times all failed. would not stay stucked to bed. When I restarted the print, it would lay down these brim lines. When the hot end got to the rear of the bed, this first strings would not stick. when it got to the front, it stuck. I even adjusted bed lil higher on back left and right corners. Made nice curves on the front but the rear didn't stick. Do I need to add some kind of stickum of some sort to the bed? Ender 3 Protried CURA 4.1,4.4,and 4.5(4.5 locked up a lot of times)Bed temp 200extruder 60, 4mm nozzle0.1220% infilwith BRIM without BRIM no differenceSkirt same results
Last edited by Bruce19; 03-28-2020 at 04:29 PM. Reason: correction
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help