Results 1 to 10 of 13
Thread: Printed gears stick together
Threaded View
-
03-02-2020, 10:32 AM #4
- Join Date
- Aug 2017
- Posts
- 95
Well, I tried the FlashForge Print slicer and if anything the problem was worse. This thing just ignores or is unable to resolve the internal gaps. The left example in the photo below was using S3D with the Makerbot 1 dual profile where you can see the vestiges of an internal gap in the gears... and the right example was with FF Print and the FF creator pro profile where you can see that the teeth are totally fused. I guess I am out of luck with this task for now since my Qidi X One that prints it perfectly won't print one as large as I need, while the Klik N Print just can't pull off the internal gaps. I really need to get a higher end printer one of these days.
Edit: I didn't see anywhere in FlashPrint where i could tweak internal gaps... unless maybe it was "shells" and "perimeter" settings?Last edited by raylo32; 03-02-2020 at 12:14 PM.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion